Is there any easy way to convert from the Key Code from GetKey to the character code for TI display (vputmap, etc.)? I have searched for a while and have not found a method. Of course, I'm doing a bit of a text editor routine and this is a must. I am about to do a mapping myself.
I noticed two things:
1. The order of character's does not match the corresponding keycode order for non alpha characters / * !...like those.
2. The lower case key codes (using the set lwrCaseActive, (IY + appLwrCaseFlag)) do not show in the ti83Plus.inc (or I can't read).
Guidance appreciated.
Convert Key Code to Character Code
Moderator: MaxCoderz Staff
- benryves
- Maxcoderz Staff
- Posts: 3089
- Joined: Thu 16 Dec, 2004 10:06 pm
- Location: Croydon, England
- Contact:
Re: Convert Key Code to Character Code
I've not used it myself, but KeyToString seems to do what you need.
Re: Convert Key Code to Character Code
This uses key tables:
http://www.ticalc.org/archives/files/fi ... 39943.html
http://www.ticalc.org/archives/files/fi ... 39943.html
Revolution Software
- benryves
- Maxcoderz Staff
- Posts: 3089
- Joined: Thu 16 Dec, 2004 10:06 pm
- Location: Croydon, England
- Contact:
Re: Convert Key Code to Character Code
It also uses GetCSC rather than GetKey.NanoWar wrote:This uses key tables:
http://www.ticalc.org/archives/files/fi ... 39943.html